Removing/replacing pcmcia options, Removing/replacing the apci card option, 3 removing/replacing pcmcia options – Texas Instruments 660 User Manual
Page 107: 4 removing/replacing the apci card option
Field Service 6-13
6.5.3 Removing/Replacing PCMCIA Options
The procedure for removing and replacing the PCMCIA options is as follows:
1.
Stop operation according to operating system (Windows 95 or Windows for
Workgroups) instructions.
2.
Press the upper card eject button to eject the upper card, lower button
controls the lower card and use both buttons for Type III devices (refer to
Figure 6-7).
3.
To replace the PCMCIA device, remove any filler cards present and insert the
device. Reinstall any external cabling required for the device.
Figure 6-7 Installing/Removing PCMCIA Options
6.5.4 Removing/Replacing the APCI Card Option
The procedure for removing and replacing the Hard Disk Drive assembly is as follows:
1.
Power down the notebook, disconnect the AC adapter, if installed, and remove
all battery packs.
2.
Disconnect any peripheral device interface cables from the external interface
PC Card
Release
Levers