Texas Instruments 660 - Manual (Page 38)

2-12 Installation
2.6 Installing the AC Power Adapter
Use the following procedures to connect the AC adapter to the system:
Caution: Use only the AC adapter supplied with the computer; other
adapters can damage the unit.
1. Remove the AC adapter from the packaging. Connect the round coaxial
connector supplied with the notebook to the DC IN power receptacle on the
left rear of the notebook as shown in Figure 2-9.
2. Connect the female side of the AC power cord to the AC adapter and connect
the male end to a grounded AC outlet.
Figure 2-9 Installing the AC Adapter
2.7 Initial Software Load
After unpacking and setting up the notebook for the first time, you must perform an
initial software load that takes approximately 30 minutes.
Because of the way Windows 95 structures its files, stopping in the middle of the setup