TP-Link TD-W8960N - Manual (Page 26)

TD-W8960N Wireless N ADSL2+ Modem Router User Guide
Figure 4-7
¾ Remove: Select the check box in the table on the screen above and then click the Remove
tab, the corresponding interface will be deleted in the table.
)
Note:
One ETH is allowed to configure as the layer 2 WAN Interface.
4.4.2 WAN Service
Choose “Advanced Setup”Æ“WAN Service”, and you will see the WAN Port Information Table in
the screen as shown below, which describes the WAN port settings and the relevant manipulation
to each interface.
Figure 4-8
After you select the Lay2 Interface, please follow the instructions below to complete the further
configuration of WAN Interface. There are five different configurations for the connection types,
which are PPPoE, IPoE, Bridge, PPPoA, and IPoA. You can select the corresponding types
according to your needs.
)
Note:
The following section adopts different VPI, VCI to introduce further configuration for the different
connection types, if you need to change the configuration of ATM PVC (VPI/VCI), you should go to
the previous section (
4.4.1 Layer2 Interface ) to configure them again.
)
Note:
ETH and ATM service can not coexist. If the ETH Interface had configured, you cannot configure
any other WAN service over the ATM Interface until the ETH Interface is deleted.
19