Tiger WonderBorg 70709 - Manual (Page 7)

12 11
2-1
Slot the hook on the frame into the hole
at the rear of the motherboard.
2-2
Press the motherboard down with your
fingers until the pawls click into place,
preventing the motherboard from being
pulled off.
2-3
Pass the motor unit cables through the
hole in the rear of the frame. Guide them
through the hole one at a time.
2-4
Plug the motor unit connectors onto the
connectors on the rear underside of
motherboard. The connector from the motor
unit installed on the left should be
plugged into the motherboard’s left
connector, and the connector from the
right motor unit should be plugged into
the motherboard’s right connector. (Do
not plug either into the motherboard’s
central connector.)
Note: Make sure the connectors are facing
the same way, as in the diagram. The four
pins of each motherboard connector should
be inserted into the holes.
2-5
When both motor unit connectors are
plugged into the motherboard, the
installation of the motherboard is complete.
Rear Front
Motherboard Motherboard
Hook
Push down into Place
Pawls
Front
Rear
Hole
Connector from
left motor unit
Connector from Left
Motor Unit Connector from
Right Motor Unit
Installing the Motherboard
3-1
Using a pair of wire-cutters, cut the plastic-
covered leg wire into lengths of about 4cm.
Cut the segments at a slight angle, so that
they will be easier to insert later. Cut
six identical segments. Use the handly
ruler on page 56 of this manual.
3-2
Using the wire-cutters, snip either "Foot
A" or "Foot B" off the runners. When you
do this, snip close to the foot. Snip out
all six units.
Note: Foot A - These work best on flat, even
surfaces.
Note: Foot B - These provide a good grip
on uneven surfaces.
3-3
Insert one end of a segment of plastic-
covered leg wire into one of the Foot A or
Foot B units, pushing it in as far as it
will go. Do the same for all six units.
3-4
Using the wire-cutters, Snip out the six
leg housings from the runner.
3-5
Insert one of the legs into a snipped-
out leg housing. Do this for all six
legs.
Foot A (or B)
Segment of a
plastic-covered
leg wire
Foot A
Foot B
Leg Housing
Leg
Fitting the Legs
Cut at a
slight angle
HARDWARE BASICS HARDWARE BASICS