SINBO SK 2396 - Manual (Page 14)

- 13 -
HOW TO OPERATE AIR POT
* Beeper will sound 5 times when water is boiled. keep warm LED will be lit.
Press RE-BOIL button if added water is not sufficient to allow unit to boil automatically.
AUTO CUT-OFF
In the event that the water runs dry, the auto CUT-OFF function of this electric air pot
would be activated. The power source would be CUT-OFF. At the same time, the beeper
sounds and a “
“ sign is displayed on LCD panel. The “REFILL”LED will also be lit.
Causes of AUTO CUT-OFF
* Power on,but water not filled.
* Water level below add water indicator but water is still boiling.
* No water is added when water is used up.
* Top cover not secured properly.
* Hot water added after power is connected.
Solution
* Allow unit to cool, add water and switch off power supply, and turn on again.
RE-BOIL FUNCTION
1. Press “RE-BOIL” button once. Re-boiling indicator light will come ON.
2. After RE-BOIL is completed, the KEEP WARM indicator light will turn on.
* Re-boil will not function if there is insufficient water inside.
Press the RE-BOIL button immediately after the water had just reached boiling level will
have no effect as the water is already at 100?.
DISPENSING WATER
1. AIR PUMP WATER OUTLET
Put the cup near water outlet, Push< the water pump lid.
(No need power)
2. AUTO DISPENSE WATER OUTLET
a) Press the “UNLOCK” button ONCE. The “UNLOCK” indicator light will come on.
b) Push the “AUTO DISPENSE ”button to dispense hot water.
3. CUP WATER OUTLET
a) Press the “UNLOCK” button ONCE. The “UNLOCK” indicator light will come on.
b) Use cup mouth touch<cup switch>water outlet at once.
* If the dispense button is not selected within 10 seconds after selecting the UNLOCK
button, the appliance will automatically revert back to the LOCK position.
The dispensing function will NOT operate if the electric air pot is not connected to the
main switch and Power switched ON.