Transcend Information CompactFlash TS16G-64GCF400 - Manual (Page 8)

T T T S S S 1 1 1 6 6 6 G G G ~ ~ ~ 6 6 6 4 4 4 G G G C C C F F F 4 4 4 0 0 0 0 0 0
400X CompactFlash Card
Transcend Information Inc.
V1.0
8
Input Leakage Current
Note: In Table 1 below, x refers to the characteristics described in table 2. For example, I1U indicates a pull-up resistor with a type 1
input characteristic.
Table 1: Input Leakage Current
Type Parameter Symbol Conditions MIN TYP MAX Units
IxZ Input Leakage Current IL Vih = Vcc / Vil = Gnd -1 1 µ A
IxU Pull-Up Resistor RPU1 Vcc = 5.0V 50k 500k Ohm
IxD Pull-Down Resistor RPD1 Vcc = 5.0V 50k 500k Ohm
Note: The minimum pull-up resistor resistance meets the PCMCIA PC Card specification of 10k ohms but is intentionally higher in the
CompactFlash Specification to reduce power use.
Input Characteristics
Table 2: Input Characteristics
MIN TYP MAX MIN TYP MAX
Type Parameter Symbol
VCC = 3.3 V VCC = 5.0 V
Units
1
Input Voltage
CMOS Vih
Vil
2.4 0.6 4.0 1 0.8
Volts
2
Input Voltage
CMOS Vih
Vil
1.5 0.6 2.0 0.8
Volts
3
Input Voltage
CMOS Schmitt
Trigger
Vth
Vtl
1.8
1.0 2.8
2.0
Volts
Notes: 1) The host provides a logic output high voltage for a CMOS load of .9 x VCC. For a 5 volt product, this translates to .9 x
4.5 = 4.05 volts minimum Voh.
Output Drive Type
Note: In Table 3 below, x refers to the characteristics described in Table 4. For example, OT3 refers to Totem pole output with a type
3 output drive characteristic.
Table 3: Output Drive Type
Type Output Type Valid Conditions
OTx Totempole Ioh & Iol
OZx Tri-State N-P Channel Ioh & Iol
OPx P-Channel Only Ioh Only
ONx N-Channel Only Iol Only