Tiger Products Co., Ltd RBF-12C - Manual (Page 60)

Operation Section 4-10
OPERATION
RBF-12C 07/04
© 2004 Alamo Group Inc.
6. PRE-OPERATION INSPECTION AND SERVICE
Before each use, a pre-operation inspection and service of the boom, attached head, and tractor must be performed.
This includes routine maintenance and scheduled lubrication, inspecting that all safety devices are equipped,
present and functional. DO NOT operate the unit if the pre-operation inspection reveals any condition affecting
safe operation. Perform repairs and replacement of damaged and missing parts as soon as noticed. By performing
a thorough pre-operation inspection and service, valuable down time and repair cost can be avoided.
¾ Tire condition/air pressure
¾ Wheel lug bolts are tight
¾ Steering linkage
¾ SMV sign is clean and visible
¾ Tractor’s lights are clean and functional
¾ Tractor Seat belt is in good condition
¾ Tractor ROPS is in good condition
¾ No tractor oil leaks
¾ Radiator free of debris
¾ Engine oil level and condition
¾ Engine coolant level and condition
¾ Power steering fluid level
¾ Fuel condition and level
¾ Sufficient lubrication at all lube points
¾ Air filter condition
6.1 Tractor Pre-Operation Inspection/Service
Refer to the tractor operator’s manual to ensure a complete pre-operation inspection and scheduled service is
performed according to the manufacturers recommendations. The following are some of the items that require
daily service and inspection:
WARNING! Periodically inspect all moving parts for wear and replace when
necessary with authorized service parts. Look for loose fasteners,
worn or broken parts, and leaky or loose fittings. Make sure all pins
have cotter pins and washers. Serious injury may occur from not
maintaining this machine in good working order.
(SG-21)
DANGER! All Safety Shields, Guards and Safety devices including
(but not limited to) - the Deflectors, Chain Guards, Steel
Guards, Gearbox Shields, PTO integral shields , and
Retractable Door Shields should be used and main-
tained in good working condition. All safety devices
should be inspected carefully at least daily for missing
or broken components. Missing, broken, or worn items
must be replaced at once to reduce the possibility of
injury or death from thrown objects, entanglement, or
blade contact.
(SGM-3)