Timex 811-095000-02NA - Manual (Page 18)

6. When you have finished setting the upper and lower target heart rate
zone limits, you can press STOP/RESET/SET (DONE) to save your
settings and exit the setting process, or you can continue to set or
adjust other heart rate statistical data (see below).
To Set Other Heart Rate Statistical Data
In addition to selecting a Target Heart Rate Zone, it is important that you
set your weight, maximum heart rate, and heart rate display. Accurate
information used by these options helps tailor your Digital Heart Rate
Monitor to your specific fitness needs.
To set other heart rate statistical data:
1. Press MODE until HRM SETUP Mode appears.
2. Press STOP/RESET/SET to enter the setting process. You will see your
selected target heart rate zone flashing on the display.
3. Press MODE (NEXT) to begin setting other statistical data.
4. Make the desired adjustment by pressing START/SPLIT (+) or HEART
RATE (-). In some setting groups pressing START/SPLIT (+) will
increase a value and pressing HEART RATE (-) will decrease a value. At
other times pressing START/SPLIT (+) or HEART RATE (-) will toggle
between two options or cycle through a setting group.
5. Press MODE (NEXT) to move to the next digit or setting group you want
to set.
31
below your chosen target heart rate zone and continue beeping until
you return to your target zone.
4. Press MODE to save your selected target heart rate zone and exit HRM
SETUP Mode. When you leave HRM SETUP Mode, the watch will use
the target heart rate zone you have selected as the basis for all HRM-
based calculations.
Manual Target Heart Rate Zone
The Manual Target Heart Rate Zone allows you to customize your lower
and upper target heart rate zone limits. You might use the Manual Target
Heart Rate Zone when the 10% range in the Preset Heart Rate Zones is
either too large or too small a range for your exercise goals.
To set the Manual Target Heart Rate Zone:
1. Press MODE until HRM SETUP Mode appears.
2. Press START/SPLIT until MANUAL appears.
3. Press STOP/RESET/SET to enter the setting process. You will see the
word MANUAL flashing on the display.
4. Press MODE (NEXT) to begin setting the upper and lower target heart
rate zones.
5. Press START/SPLIT (+) to increase the flashing value, HEART RATE (-)
to decrease the flashing value, or MODE (NEXT) to move to the next
digit’s value.
30
W246_NA_EN.qxp 12/5/08 12:36 PM Page 30