Toshiba B-EP4DL - Manual (Page 23)

Symptom Point to check (Cause) Solution
Issue mode is incorrect. Select a correct issue mode.
Transmission speed is incorrect. Send data at correct transmission
speed.
The printer is not turned on. Turn on the printer.
Serial interface cable is connected.
(GH20 only) Disconnect the RS-232C cable from
the printer.
The printer is communicating via
wireless communication.
(GH30/GH40 only) Terminate the wireless communication
The printer cannot
communicate via USB.
Issue mode is incorrect. Select a correct issue mode.
The printer is not turned on. Turn on the printer.
The interface cable is not connected
properly. Completely connect the interface
cable.
Issue mode is incorrect. Select a correct issue mode.
The printer cannot
communicate via serial
interface (GH20 only)
Transmission speed is incorrect. Send data at correct transmission
speed.
The printer is not turned on. Turn on the printer.
Distance to the host is too far. Bring the printer close to the host
within 3 m.
The printer is used in a location
where it is subjected to noise or
interference. Avoid such location.
The printer address is not correctly
set on the host. Correctly set the print address on the
host.
The printer cannot
communicate via
Bluetooth.
(GH30 only)
Issue mode is incorrect. Select a correct issue mode.
The printer is not turned on. Turn on the printer.
Distance to the host is too far. Bring the printer within a wireless
coverage area.
Obstacles block the radio wave. Use the printer in a location with no
obstacles.
The printer is used in a location
where it is subjected to noise or
interference. Avoid such location.
The printer address is not correctly
set on the host. Correctly set the print address on the
host
Channel setting for the access point
or host is incorrect. Avoid using a channel which interferes
with adjacent access points.
The printer cannot
communicate via wireless
LAN.
(GH40 only)
Issue mode is incorrect. Select a correct issue mode.
The print head is dirty. Clean the print head.
The media is not loaded properly. Load the media properly.
Deteriorated media is used. Load a new media roll.
Printout is too light.
The media is not a TOSHIBA TEC
approved one Use TOSHIBA TEC approved media.
The STATUS lamp is lit or blinking. Clear the error
The printer received print
data but does not print.
The media is not loaded properly. Load the media properly.