Tamron Digital Compact Hi-Fi System CE510S - Manual (Page 5)

9 10
TAPE OPERATION
GENERAL INFORMATION ON CASSETTE TAPES
• For playback, use normal (low-noise) tape for best sound. (Metal or chrome tape is not
recommended.)
• For recording, use normal tape only.
• Do not use C-120 tapes, tapes with internal reels or pool-quality tapes because they can
cause malfunctions.
• Before loading a tape into the cassette compartment, tighten the slack tape with a pen or
pencil.
• Cassette have removable which prevent accidental recording from taking place. Removing
the tab on the top left protects the disc facing you from erasure. Cover the tab holes with
adhesive tape to erase or record again.
CASSETTE PLAYBACK
1. Set the FUNCTION switch [9] to TAPE mode.
2. Press the STOP/ EJECT button [16] and insert a pre-recorded cassette tape into the cassette
compartment.
3. Close the cassette door.
4. Press the PLAY button [13] to start playback.
5. Press the STOP/ EJECT button to stop playback. Also, playback will stop automatically when
the end of the tape has been reached.
Fast forward/rewind
1. Press the F.FWD button [15] to avance the tape or press the REW button [14] to rewind.
2. Press the STOP/ EJECT button when the desired location has been reached
NOTE: In fast forward mode, the tape will not automatically stop when it reaches the end. It must
be stopped manually to avoid damage to the tape and/or mechanism.
Interrupt playback
Press the PAUSE button [17] during playback and press it again to resume playback.
RECORDING
• When recording important selections, be sure to make a preliminary test to ensure that the
desired material is being properly recorded.
• The ALC (Automatic Level control) circuit automatically controls the level of the input signal
used for recording.
• Metal and chorme tapes cannot be used for recording.
STOP THE PLAY MODE
Simply press the STOP button [4] to stop the play mode.
RECORDING FROM RADIO
1. Set the FUNCTION switch [9] to “RADIO” mode.
2. Set the BAND selector [10] to the desired band.
3. Press the REPEAT/ MEM. UP button [6] to select the preset station, or use the F. SKIP/
TUNING UP/ ADJ. UP button [2] and B. SKIP/ TUNING DOWN/ ADJ. DOWN [3] to tune in
the desired station.
4. Insert a cassette tape into the cassette compartment.
5. Press RECORD button [12] which also engages the play button, to being recording.
6. Press the PAUSE button [17] to suspend recording without deactivating the record mode.
Press again to resume recording.
Beat Cut switch
If feedback (whistling noise) occurs when recording from AM(MW) broadcasts, set the BEAT
CUT selector [22] to I or II whichever gives the best reception.
RECORDING FROM CD
1. Set the FUNCTION switch [9] to “CD” mode.
2. Place a compact disc in the CD compartment.
3. Insert a cassette tape into the cassette compartment.
4. Press the RECORD button [12], which also activates the PLAY/ PAUSE button [1] of the CD
player, to begin recording. When pressing the STOP/ EJECT button [16] to stop recording,
the CD playing will pause automatically.
ERASING RECORDED TAPES
1. Insert the tape to be erased into cassette compartment.
2. Set the FUNCTION switch [9] to “TAPE” mode.
3. Press the RECORD button [12] to begin erasing.