Toshiba S2T - Manual (Page 4)

Page 4
T-PDS Setup:
In T-PDS under the Option Menu, select Communications. Set as follows:
Using T-PDS, set the following in special register SW63:
This completes the T-PDS setup. T-PDS can now be connected to the S2E via Ethernet
through the GEN651A Ethernet module.
Note: If an attempt is made to assign an IP address in T-PDS before the computer’s Ethernet
card is assigned a corresponding IP address, then T-PDS will return a Win Socket error.
This setting can also be made
in the ladder logic with a MOV
instruction.