Tech4o Alti-Ski - Manual (Page 6)

10 11
• To view the stopwatch, press the [o/-] button three times while in
date/time mode.
• When the stopwatch is selected, the watch will display StP 1 in the
top row and 0:00 in the bottom row.
5.1 Stopwatch Mode - Setting
• In stopwatch mode, press and hold the [s/+] button for two
seconds.
• The LAP/INT indicator will flash.
• Both LAP and intermediate settings will record time the same way,
but the way the information is displayed will vary. The LAP setting
will show the last lap time when the [s/+] or [o/o] buttons are
pushed and in stopwatch history mode. The Intermediate setting
will show the cumulative intermediate times when the [s/+] or
[o/o] buttons are pushed and in stopwatch history mode.
• Use the [o/-] button to select between LAP and int settings. Press
the [o/o] button to confirm selection.
5.2 Stopwatch Mode - Using the Stopwatch
How to use the Stopwatch
• When in stopwatch mode, press the [o/o] button to start the
stopwatch. The top row will now display ------------- and the
bottom row will display the current stopwatch time.
• Press the [o/o] button again to stop the stopwatch. The top and
bottom rows will now display current stopwatch time.
• Press the [o/o] button again to resume the stopwatch. The top row
will now display ------------- and the bottom row will display the
current stopwatch time.
• While the stopwatch is running, you may enter LAP/INT times by
pressing the [s/+] button. The top row will display the first LAP/
INT time and the bottom row will display the cumulative stopwatch
time.
• After each successive LAP/INT time is entered, the top row will
display:
* the cumulative time of all the entered intermediate times
if the int setting was selected; or
* the last lap time if the lap setting was selected.
• The bottom row will display the cumulative stopwatch time.
• When the stopwatch is stopped, press the [o/-] button to proceed
to the stopwatch history mode or press [s/+] to proceed to the
next available stopwatch to begin recording another set of times
following the steps above. Note: there are 5 available stopwatches.
More stopwatch information can be recorded by clearing
stopwatch data in the stopwatch history mode or by recording
over stopwatch #5.