If you forget the password, Boot-up function, System requirements for boot-up function – Transcend Information 32MB4GB User Manual
Page 14: Boot-up function for windows 98/98se and me
12
6. Click OK to close this window.
If You Forget the Password
When you forget the password, all you can to use JetFlash again is run the U-Storage Tool
to repartition JetFlash. Unfortunately, all data on JetFlash will be lost during this procedure.
Boot-Up Function
For systems that use Windows 98/98SE, Me, or XP, JetFlash can be configured to serve as
an MS-DOS Boot Disk. Upon completion of this procedure, JetFlash can be used to boot-up
your computer, allowing you to run MS-DOS programs. This does not make JetFlash a
Rescue Disk for Windows, nor does it put Windows Startup files onto JetFlash. After booting
with JetFlash, if you wish to enter Windows, you must then start Windows from your hard
drive or a previously created Rescue Disk.
The boot-up function is not supported in Windows 2000.
System Requirements for Boot-up Function
•
A desktop or notebook computer that supports USB-ZIP or USB-HDD as the First
Boot Device in BIOS
•
Windows 98/98SE, Me, or XP located on drive C
•
Any anti-virus program present must be turned off
Boot-Up Function for Windows 98/98SE and Me
Skip steps 1-2 if the U-Storage Tool has already been installed.
1. Put the Driver CD into the CD-ROM drive (Auto-Run supported). Click the U-Storage Tool
button.