Technics SC-EH760 - Manual (Page 7)

7
Before use
RQT5355
EXT
LOOP
AM ANT
5–12m
A
EXT
LOOP
75 ∞
AM ANT
FM ANT
75 ∞
FM ANT
GND
EXT
LOOP
AM ANT
A
A
15mm
30mm
1
Flat cables.
Keep the cables as flat as possible against the back of the
unit.
Note
Connect the black connectors to the black terminals and the
blue connector to the blue terminal. Incorrect connection of the
flat cables can damage the unit.
2
FM antenna.
Fix the other end of the antenna where reception is best.
3
AM loop antenna.
1 Attach the antenna holder to the rear panel of the CD
changer or CD player.
Then clamp the antenna into the antenna holder.
2 Connect the antenna terminal to the rear panel of the tuner
amplifier.
Keep loose antenna cord away from other wires and cords.
4
Front (L/R) speaker cables.
Connect the cables to the terminals of the same color.
Note
³ To prevent damage to circuitry, never short-circuit positive
(
i ) and negative ( j ) speaker wires.
³ Be sure to connect only positive (red, blue or gray) wires to
positive (
i ) terminals and negative (black) wires to negative
( j ) terminals.
5
[SC-EH760]
Surround and center speaker cables.
6
AC mains lead.
Insertion of connector
Even when the connector is perfectly inserted, depending on
the type of inlet used, the front part of the connector may jut
out as shown in the drawing.
However there is no problem using the unit.
Note
The included AC mains lead is for use with this unit only. Do not use it
with other equipment.
For your reference:
Information you enter into the unit’s memory, except for time, remains
intact for up to two weeks after the mains lead is disconnected.
(For United Kingdom only)
BE SURE TO READ THE CAUTION FOR THE
AC MAINS LEAD ON PAGE 4 BEFORE PRO-
CEEDING TO STEP 6.
Optional antenna
connections
Use outdoor antennas if radio reception is poor.
FM outdoor antenna
Note
³ Disconnect the FM indoor antenna.
³ The antenna should be installed by a competent technician.
FM outdoor antenna
1 Remove a piece of the outer vinyl
insulator.
2 Twist the shield braid to expose the
core wire.
Core wire Shield braid
Use the antenna
plug adaptor
(included).
75 ­ coaxial cable
(not included)
(United Kingdom only)
(For Australia and N.Z.)
(For others)
Tuner amplifier
AM outdoor antenna
Run a piece of vinyl wire horizontally across a window or other con-
venient location.
Note
³ Leave the loop antenna connected.
³ Disconnect the antenna when the unit is not in use. Do not use the
antenna during an electrical storm.
AM outdoor antenna
Tuner
amplifier
Before connection
³ Do not connect the AC mains lead until all other connections
are complete.
³ To prepare the AM loop antenna and speaker cables (and
FM antenna for Australia and N.Z.), twist the vinyl tip and pull
off (
[A] ).