Tyan Computer Transport GS10 B2094T15 - Manual (Page 46)

46
http://www.TYAN.com
NOTE: You cannot replace the cabinet cover with a CD drive installed. Restore the old
connections after using the CD drive to be able to replace the cabinet cover.
Without a Secondary Hard Disk Drive Installed
1. Remove the cabinet cover (see section 6.1 in this chapter).
2. Connect one end of the data cable to the secondary IDE connector (see figure on page 44) and
the other end to the rear of the CD drive.
3. Connect the power cord to the rear of the CD drive.
NOTE: You cannot replace the cabinet cover with a CD drive installed. Remove the CD
drive after using it to be able to replace the cabinet cover.
Three -headed data cable