Tyan Computer Transport GS10 B2094T15 - Manual (Page 50)

50
http://www.TYAN.com
3. Press
Y
for the Create and Duplicate option. The messages as shown next will appear asking
you to select the Source drive to use.
Source Disk
Channel:ID Drive Model Capacity (MB)
Target Disk
Channel:ID Drive Model Capacity (MB)
[Please Select A Source Disk]
Channel:ID Drive Model Capacity (MB)
1: Master QUANTUMCR8.4A 8063
2: Master QUANTUMCR8.4A 8063
[
↑
] Up [
↓
] [ESC] Exit [Ctrl- Y] Save
4. Use the arrow keys to select the drive containing data to be copied.
5. Press
Ctrl
+
Y
to save and start duplication.
6. Press
Y
when the messages appear asking if you want to continue. FastBuild Utility will then
copy all data from the Source drive to the Target drive.
7. When messages appear on the screen indicating that the array has been creat ed, press any key
to reboot.
7.3 Viewing Drive Assignments
You can view whether drives are assigned to a disk array or are unassigned. The View Drive
Assignments screen indicates the channel ID, drive model, capacity, assignment and mode (data
transfer rate: U6 = 133 MB/sec, U5 = 100 MB/sec and U4 = 66 MB/sec).
To view drive assignments, access the main menu (as described in section 7.2 steps 1 and 2) and
select
2.
FastBuild ™ Utility 1.xx © 199x- 200x Promise Technology, Inc.
[View Drive Assignments]
Channel:ID Drive Model Capacity(MB) Assignment Mode
1: Master QUANTUMCR8.4A 8063 Array 1 U5
2: Master QUANTUMCR8.4A 8063 Array 1 U5
[Keys Available]
[ ↑ ] Up [ ↓ ] Down [ESC] Exit Mode (U=UDMA, P=PIO, D=DMA)