TANDBERG 8000 MXP - Manual (Page 25)

Installation
11
2.1 Unpacking and Mounting
Unpacking the System
To avoid damage to the unit during transportation the system is delivered as separate
components:
ƒ Base
ƒ Monitor
Frame
ƒ Two Plasma Monitors
Together with the Base you will find the monitor connector units, the monitor rear covers and the
accessories box which will contain the following:
ƒ W.A.V.E. II Camera
ƒ Three Table Microphones
ƒ Remote Control and Tracker with batteries
ƒ Cables
ƒ Documentation
Unpacking the Base
Due to the weight of the system, the base should be placed in its permanent location as soon as
it is unpacked.
Unpacking and Installing the Monitor Frame
Lift the monitor frame out of the box. Do not remove the straps or packaging that are around the
rack. Place the rack on top of the base. Make sure that the cables from the base do not get stuck
in between. You will find 4 bolts sticking out at the rear end of the base. Use the 4 nuts to fasten
the monitor frame in place. You can now remove the straps and packaging from the monitor
frame.
IMPORTANT: Put your fingers in the holes on the side of the plastic cover and carefully flip down
the plastic cover. Two persons should carry out this operation to avoid too much stress on the
plastic cover. 4 hexagonal-shaped screws should be used to secure the monitor frame to the top
of the Base. There are 2 holes
located on each side. The front cover is made of plastic and should be treated with care.
Installing the monitor(s)
We recommend that there are 3 people present when installing the monitor(s):
ƒ Remove the plastic plugs located on the back of the monitor(s). Check to see where the
holes in the monitor frame are located.
ƒ Take the monitor(s) and place it (them) inside the monitor frame.
ƒ Secure each monitor with the 8mm hexagonal-shaped screws.
ƒ Remove the protective plastic film from the monitor front.
ƒ The monitor connector units should be mounted at the rear of each monitor. Please see
the instruction that comes with the connector (video) unit for correct installation.