Tyco Electronics 4200L - Manual (Page 18)

User Manual – Interactive Digital Signage
SW601176 Rev A - Page 18 of 45
Note:
Do not lose the touchmonitor’s APR Calibration USB Drive or APR
Calibration file! It is unique to your touchmonitor, and required for
that touchmonitor to function.
If you connect this touchmonitor to a different computer, or if you
update the touch driver on your computer, you will need to use the APR
Calibration USB Drive again.
Operating System Setup – No OS
Load your desired operating system onto the Computer Module. The easiest way to do this
will probably be using an image or recovery disk on a USB external DVD-ROM drive connected
to the Computer Module.
Cancel any attempts by your operating system to load drivers for the new USB device (the Elo
touchscreen) it finds.
Installing the APR Touch Software
(for Elo Computer Modules with No OS)
Some software installation is required for your touchmonitor to work on the Computer Module.
Visit the Elo TouchSystems website www.elotouch.com for:
• The latest versions of our touch drivers
• Additional touch driver information
• Detailed touch driver installation guides
• Touch drivers for other operating systems
1. Install the driver onto your computer
• Obtain the necessary APR touch driver from the Elo Touchsystems website
www.elotouch.com
• Follow the steps given by the Elo installation program.
2. Install the APR Calibration file onto your computer.
• Make sure the APR driver has been installed first.
• Insert the touchmonitor’s unique APR Calibration USB Drive into one of the Computer
Module’s USB ports.
• The APR Calibration USB Drive contains only one file. Copy this file into the folder
“C:\Program Files\EloTouchSystems\APRdata”
• Rename the file to “AprCF.bin”