The Singing Machine STVG-512 - Manual (Page 12)

D
!
Warning - Tapping or dropping the microphone while it is on can permanently damage
your microphone. Resist the urge to swing the microphone around by the cord!
PREPARATION
PLAYING CD OR CD+G DISC
TURNING POWER ON/OFF
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
This unit is designed to play CD’s bearing the identification logo . If CD’s do not
conform to the CD standard, they may not play properly.
Fingerprints and dust should be carefully wiped off with a soft cloth. Wipe in a straight motion
from the center of the disc to the outside edge.
Never use chemicals, such as record cleaning sprays, antistatic sprays or fluids, benzene or
thinner to clean compact discs. These chemicals will permanently damage the plastic
surface of the disc.
Always place the compact disc on the disc tray with the label facing upward. Compact discs
can be played on only one side.
To remove a disc from its storage case, press down on the center of the case and lift the disc
out, holding it carefully by the edges.
Discs should be returned to their cases after use to protect them from dust and scratches.
To prevent warping the disc, do not expose it to direct sunlight, high humidity or high
temperatures for extended periods of time.
Do not apply paper or write anything on either side of the disc. The inks used in some felt-tips
pens may damage the surfaces of the disc.
Reminders:
Adjust MASTER VOLUME control on your unit, TV or audio system to a comfortable level.
Adjust MIC/ECHO/BALANCE controls as needed to achieve the desired mix of music and
vocals through your TV or sound system.
Do not press the disc cover of the CD compartment while it’s playing.
Never place anything except a compact disc on the disc tray. Foreign objects can damage
the unit.
Do not apply excessive force to disc cover.
Only place one disc on the disc tray at a time.
To turn on the karaoke center, press the ON/OFF button, the ON/OFF LED will light up.
To turn off the system, press the ON/OFF button again, the ON/OFF LED will turn off.
" "
Lift up the CD door to open the CD/CDG compartment. Place a disc in the compartment with
the printing side facing upward and the shiny side facing down.
(If no disc is loaded, it will display “ ”.)
Gently close the CD door to the CD/CDG compartment. After a few seconds, the LED will
display the total number of tracks.
(Refer to the Trouble Shooting Guide on page E14 if a disc is loaded but the total tracks
do not appear.)
FUNCTION SELECT
LOADING A DISC
Set the FUNCTION SELECT switch to CD+G.
!
CD OR CD+G OPERATION
E11
ENGLISH