Toshiba TCB-AX21UL - Manual (Page 11)

Wireless remote controller kit
Installation Manual
– 10 –
EN
To operate a group control of multiple indoor units by 2 remote
controllers
MAIN and SUB remote controllers are operable even if they are installed to any indoor unit.
(Total cable length: Within 656’2” (200 m))
7
HOW TO SET THE ROOM TEMPERATURE
SENSOR
• The room temperature sensors are equipped in the indoor unit and the wireless remote
controller.
One of two sensors works.
• The room temperature sensor is set to the indoor unit side as factory default.
To select the sensor in the remote controller, push the SENSOR button (figure below)
inside of the remote controller cover and check “
” disappears from LCD.
NOTE
If the room temperature data from the remote controller
is not transmitted to the unit for 10 minutes or more, the
sensor at indoor unit side is automatically selected
even if the sensor at the remote controller side is
selected.
Fix the remote controller toward the unit as possible.
Wireless remote
controller kit Wired remote
controller (SUB)
(Sold separately)
Remote controller inter-unit
cable for group control
(Field procurement)
(AWG20 (0.5 mm
2 ))
(UL wires rated 300 V)
Ground
Terminal block for
remote controller
cable
Signal receiving unit
Ground Ground Ground
Indoor unit
No.1
Indoor unit
No.2
Indoor unit
No.3
Indoor unit
No.4
SENSOR button
10-EN
+00EH99677601_01EN_remo_IM.book Page 10 Thursday, October 8, 2009 4:12 PM