Switch location of signal receiving unit – Toshiba TCB-AX21UL User Manual
Page 4
Wireless remote controller kit
Installation Manual
– 3 –
2
SWITCH LOCATION OF SIGNAL RECEIVING
UNIT
1
3
2
4
6
5
Screw
Remove
Face plate
Remove the face plate from Signal receiving unit.
Signal receiving unit
Address selector switch
This switch is used to address one of a
maximum of six air conditioners that can
be controlled by the remote controller.
(Refer to page 11.)
All
x
{
/NORMAL selector switch
Set this switch to the “NORMAL” position for the normal operation of the air conditioner. When this switch is set to the
“All
x
{
” position, the indoor unit of the air conditioner is turned off.
RCU:SUB/RCU:MAIN selector switch
Set this switch to the “RCU:MAIN” position for normal operation. Refer to page 9 for setting to the “RCU:SUB” position.
PCB CHK switch
This switch is not used and should be set in the position shown in the figure.
TEST RUN switch
This switch is used for test running.
3-EN
+00EH99677601_01EN_remo_IM.book Page 3 Thursday, October 8, 2009 4:12 PM