Verifying telephone connectivity, 3adding new devices to your network – Technicolor - Thomson TG787 User Manual
Page 32
E-DOC-CTC-20080118-0051 v2.0
26
3
Adding New Devices to your Network
4
Enter the IP address and the port number of the registrar, and the proxy, as provided by your ISP:
5
Click Apply.
Verifying Telephone Connectivity
Proceed as follows to verify the voice connection:
1
Make sure the Thomson Gateway is turned on and ready for service.
2
Check whether your phone is properly attached to the Thomson Gateway.
3
Make sure the Internet telephony service is enabled and configured.
4
The Voice LED must be solid green.
5
Pick up your phone, wait for the dialling tone, and dial the number. If you dial a ‘#’ after the phone
number, the phone number will be called instantly.
The phone(s) attached to the Thomson Gateway can receive incoming VoIP calls, as long as your
Thomson Gateway is turned on and the Voice LED is lit.
For calls over the analogue phone line, your phones are line-powered by the telephone company
and can therefore always be reached, even if the Thomson Gateway is turned off.