Telex Plasma Series - Manual (Page 8)

ELECTRO-VOICE ® Plasma Owner’s Manual 7
Setup Diagrams for Plasma
· Plug a line input into either the ¼-inch or the 3-pin XLR-type input connector. The ¼- inch input is
in the center of the XLR connector and can accept unbalanced or balanced lines (TRS ¼-inch).
The line input level required to drive the unit to full power is from – 12 dBu to 0 dBu. The
system’s level control regulates the overall output level of the system.
Figure 1a:
Rear Panel Plasma P1
Figure 1b:
Rear Panel Plasma P2