Tandberg Data FS-1610 - Manual (Page 14)

Tandberg Data Setting Up
_____________________________________________________________
2-2 Tandberg Viking FS-1600 Series NAS Hardware User Manual
.
2.1.3. Rack Mounting
When mounting your FS-1600 Series NAS appliance into a cabinet
(equipment rack), make sure you maintain correct mechanical load leveling
to avoid hazardous conditions.
2.1.4. Power Source
The FS-1600 Series NAS appliance should be operated using only the type
of power source indicated on the product label.
• Voltage: 100-240 V
• Current: 4-10 A
• Frequency: 50/60 Hz
2.1.5. Circuit Overloading
Appropriate consideration should be given when connecting the supply
circuit to the FS-1600 Series NAS appliance to avoid any circuit overload.
The system nameplate rating should be used when addressing concerns
about circuit overload.
Warning
Make sure that the site has the necessary capacity to handle the FS-1600
Series NAS appliance. Overloading electrical supply circuits is extremely
hazardous.
2.1.6. Reliable Grounding
To avoid the potential for an electrical shock hazard, the rack assembly itself
must be suitably grounded, according to your local regional electrical codes.
This typically will require the rack to have its own separate ground. We
recommend you consult your local approved electrician.
2.1.7. Electrical Shock
Do not operate the FS-1600 Series NAS appliance without the top cover in
place. Opening or removing the cover may expose you to dangerous voltage
and can cause electrical shock.
2.1.8. Battery Precaution
There may be a danger of explosion if the CMOS battery is incorrectly
replaced. Replace this battery with model CR2032 only. Use of another
battery may present a risk of fire or explosion. Dispose of used batteries
according to manufacturer's instructions.