Tandberg Data FS-1610 - Manual (Page 31)

Tandberg Data Customizing the Viking FS-1600 Series NAS Appliance
_____________________________________________________________
4-3 Tandberg Viking FS-1600 Series NAS Hardware User Manual
3. Remove the front bezel by pressing the release latch on right side of
the front bezel, then pulling out the bezel.
4. Remove the defective hard drive by raising the hard drive carrier
handle, then sliding the hard drive carrier out of the bay.
5. Install a new drive into the hard drive carrier. Make sure that the new
hard drive is the same drive size as the failed hard drive.
6. Insert the hard drive carrier into the bay and lock it into place.
7. Replace the front bezel, then lock the control bay cover. The new
hard drive’s status LED lights up. The RAID will rebuild
automatically.