Texas Instruments TMS320DM643X DMP - Manual (Page 31)

www.ti.com Registers
3.8 Line Status Register (LSR)
The line status register (LSR) is shown in Figure 16 and described in Table 17 . LSR provides information
to the CPU concerning the status of data transfers. LSR is intended for read operations only; do not write
to this register. Bits 1 through 4 record the error conditions that produce a receiver line status interrupt.
Figure 16. Line Status Register (LSR)
31 16
Reserved
R-0
15 8 7 6 5 4 3 2 1 0
Reserved RXFIFOE TEMT THRE BI FE PE OE DR
R-0 R-0 R-1 R-1 R-0 R-0 R-0 R-0 R-0
LEGEND: R = Read only; -n = value after reset
Table 17. Line Status Register (LSR) Field Descriptions
Bit Field Value Description
31-8 Reserved 0 Reserved
7 RXFIFOE Receiver FIFO error.
In non-FIFO mode:
0 There has been no error, or RXFIFOE was cleared because the CPU read the erroneous character
from the receiver buffer register (RBR).
1 There is a parity error, framing error, or break indicator in the receiver buffer register (RBR).
In FIFO mode:
0 There has been no error, or RXFIFOE was cleared because the CPU read the erroneous character
from the receiver FIFO and there are no more errors in the receiver FIFO.
1 At least one parity error, framing error, or break indicator in the receiver FIFO.
6 TEMT Transmitter empty (TEMT) indicator.
In non-FIFO mode:
0 Either the transmitter holding register (THR) or the transmitter shift register (TSR) contains a data
character.
1 Both the transmitter holding register (THR) and the transmitter shift register (TSR) are empty.
In FIFO mode:
0 Either the transmitter FIFO or the transmitter shift register (TSR) contains a data character.
1 Both the transmitter FIFO and the transmitter shift register (TSR) are empty.
5 THRE Transmitter holding register empty (THRE) indicator. If the THRE bit is set and the corresponding
interrupt enable bit is set (ETBEI = 1 in IER), an interrupt request is generated.
In non-FIFO mode:
0 Transmitter holding register (THR) is not empty. THR has been loaded by the CPU.
1 Transmitter holding register (THR) is empty (ready to accept a new character). The content of THR has
been transferred to the transmitter shift register (TSR).
In FIFO mode:
0 Transmitter FIFO is not empty. At least one character has been written to the transmitter FIFO. You can
write to the transmitter FIFO if it is not full.
1 Transmitter FIFO is empty. The last character in the FIFO has been transferred to the transmitter shift
register (TSR).
31 SPRU997C – December 2009 Universal Asynchronous Receiver/Transmitter (UART)
Submit Documentation Feedback
Copyright © 2009, Texas Instruments Incorporated