Therma-Stor Products Group Phoenix 200 HT - Manual (Page 2)

2 www.thermastor.com • [email protected] Toll-Free 1-800-533-7533
1 Specifications
Part No. 4025900
Power 7.5 amps, 0-20 VAC, Grounded
Water 40 pints/day @ AHAM (80 ° F, 60%)
Removal 26 pints/day @ saturation
32 gal/day maximum @ saturation
Blower 325 CFM without external ducting
30 CFM @ .5 IWG external static
Operating 33°F min., 25°F max.
Range
Refrigerant  lbs., 4 oz. R-22
Charge
Filters 6” x 20” x 2” Pleated Media MERV-
Duct Options Intake – 2” Flex-Duct
Supply – 0” Lay-Flat
Warranty Five years;
st year 00% of Parts and Labor
2nd–5th year 00% of Parts of sealed
refrigeration system.
Dimensions
Machine Shipping
Width 20.25” 24”
Height 40” 45.25”
Depth 2.375” 25.5”
Weight 38 lb 64 lb
2 Operation
2.1 Transporting
The Phoenix 200 HT must always be upright when
transported by vehicle. It may be tipped onto its handle
and back for loading and moving by hand. The Phoenix
200 HT features a high-impact plastic skid plate which
protects the unit while navigating obstacles such as curbs,
stairways, and while loading into vehicles.
2.2 Electrical Requirements
The Phoenix 200 HT plugs into a common grounded outlet
on a 5 Amp circuit. It draws 7.5 Amps at 80°F, 60% RH.
If used in a wet area, a ground fault interrupter (GFI) is
required. If an extension cord is required, it must have a
minimum of 4 gauge conductors if 25 feet long or less
and 2 gauge conductors if greater than 25 feet long.
Read the operation and maintenance instructions
carefully before using this unit. Proper adherence to these
instructions is essential to obtain maximum benefit from
your Phoenix 200 HT dehumidifier.
• It is designed to be used INDOORS ONLY.
• If used in a wet area, plug it into a GROUND FAULT IN-
TERRUPTER.
• DO NOT use the Phoenix 200 HT as a bench or table.
• It must always be used in the upright position.
Table of Contents
Introduction ................................................................
1. Specifications ........................................................2
2. Operation .............................................................2
2. Transporting ...................................................2
2.2 Electrical Requirements ..................................2
2.3 Condensate Removal ......................................2
2.4 Ducting ...........................................................2
2.5 Power Switch .................................................3
2.6 Pump Purge Switch .........................................3
2.7 Hour Meter ....................................................3
2.8 Temperature Specific Operation .......................3
2.9 Low Pressure Control ......................................4
3. Maintenance .........................................................4
3. Air Filter .........................................................4
3.2 Storage .........................................................4
4. Service ................................................................. 4
4. Technical description ......................................5
4.2 Troubleshooting ..............................................5
4.3 Blower Replacement .......................................6
4.4 Defrost Thermostat and Timer .........................6
4.5 Condensate Pump ..........................................6
4.6 Gravity Drain Option ........................................6
4.7 Relay ..............................................................7
5. Options and Accessories .......................................7
6. Wiring Diagram ....................................................7
7. Service Parts .......................................................8
8. Warranty ..............................................................9
Serial No. ___________________________
Purchase Date ______/______/_____
Dealer’s Name ___________________________________