Thermador HSW - Manual (Page 9)

Page 1
READ AND SAVE THESE INSTRUCTIONS
WARNING - TO REDUCE THE RISK
OF FIRE, ELECTRIC SHOCK, OR
INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
CAUTION: FOR GENERAL
VENTILATING USE ONLY. DO
NOT USE TO EXHAUST
HAZARDOUS OR EXPLO–SIVE
MATERIALS OR VAPORS
.
A. Use this unit only in the manner
intended by the manufacturer. If
you have questions, contact the
manufacturer.
B. Before servicing or cleaning the
unit, switch power off at service
panel and lock service panel
disconnecting means to prevent
power from being switched on
accidentally. When the service
disconnecting means cannot be
locked, attach a tag to the service
IMPORTANT SAFETY INSTRUCTIONS
PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING.
INSTALLATION MUST COMPLY WITH ALL LOCAL CODES.
IMPORTANT: Save these Instructions for the Local Electrical Inspector’s use.
INSTALLER: Please leave these Instructions with this unit for the owner.
OWNER: Please retain these instructions for future reference.
Safety Warning: Turn off power circuit at the service entrance and
lock-out panel, before wiring this appliance.
Requirement: 120 V AC, 60 Hz. 15 Amp branch circuit (Appliance Rating see Table 1)
L933C Ed. 05/98
panel to indicate power has been
switched off for maintenance.
C. Installation Work and Electrical
Wiring Must Be Done By Qualified
Person(s) In Accordance With All
Applicable Codes & Standards,
Including Fire-rated Construction.
D. Sufficient air is needed for proper
combustion and exhausting of
gases through the flue (chimney)
of fuel burning equipment to
prevent back- drafting. Follow the
heating equipment manufacturers
guideline and safety standards
such as those published by the
National Fire Protection Assoc-
iation (NFPA), the American
Society for Heating, Refrigeration
and Air Conditioning Engineers
(ASHRAE), and the local code
authorities.
INSTALLATION INSTRUCTIONS
WALL HOOD SERIES:
HDW, HSW, HCSW, HGSW, HTSW
FOR RESIDENTIAL USE ONLY
NOT TO BE INSTALLED OVER GAS GRILLS