Topcom 4011C SIM - Manual (Page 23)

Topcom Butler 4011/4011C Sim 23
Topcom Butler 4011/4011C Sim
ENGLIS
H
4.23 Subscribing a handset to a B24xx, 28xx, 29xx, 32xx, 40xx, 46xx
In order to be able to make and receive telephone calls, a new handset has to be subscribed
to the base unit. You can subscribe 5 handsets to one base unit. By default, each handset is
subscribed as handset 1 on the base unit upon delivery (base unit 1).
!!! You only need to subscribe the handset if:
•
the handset subscription has been removed from the base unit (e.g. for reinitialisation)
• you want to subscribe a different handset to this base unit.
The underlined procedure is only applicable to a B40XX handset and base unit!!
Keep the Paging key
on the base unit pressed for 10 seconds until The Line/Charge
indicator on the base unit begins to blink rapidly. The Line/Charge indicator will blink
rapidly for one minute. During this minute, the base unit is in subscribing mode and you must
do the following to subscribe the handset:
•
Press the Programming key .
• Press the Up or Down key repeatedly until ‘BASE SUB’ appears on the display.
• Press the Programming key .
• ‘BASE _‘ appears on the display.
• Enter a number of the base unit you would like to subscribe the handset to (1-4). Use the
number keypad.
• ‘SEARCHING’ and the symbol appears on the display.
• The RFPI code (each base unit has a unique RFPI code) appears on the display and a
signal sounds when the handset has found the base unit.
• Press the Programming key .
• ‘PIN’ appears on the display.
• Enter the 4-digit PIN code of the base unit in (default PIN code is ‘0000’). Use the
number keypad.
• Press the Programming key .
• The handset is subscribed to the base unit.
4.24 Subscribing Butler 4011 handset on another base (other brand/model)
Put the base in subscription mode (see manual of the base). If the base is in subscribing
mode, you have to do the following to subscribe the handset:
•
Press the Programming key .
• Press the Up or Down key repeatedly until ‘BASE SUB’ appears on the display.
• Press the Programming key .
• ‘BASE _‘ appears on the display.
• Enter a number for the base unit to which you would like to subscribe the handset (1-4).
• Use the number keypad.
• ‘SEARCHING’ and the symbol appear on the display.
Each handset can be subscribed to 4 different DECT base units. Each base
unit is assigned a number from 1 to 4 in the handset. When you subscribe a
new handset, you can assign a base unit number. It is best to use ‘1’.