Tekkeon MP3450 R2 - Manual (Page 13)

12
View myPower ALL Plus Battery Capacity
The capacity in myPower ALL Plus will decrease as the battery powers and/or charges your devices.
The remaining capacity is shown on the voltage indicator, which is accessed as described below. As the
remaining capacity decreases, the lights will turn off in sequence from right to left. When the myPower ALL Plus
battery capacity is low, only the first capacity indicator will be on. You should recharge myPower ALL Plus at this
time. When myPower ALL Plus is completely out of battery, all lights will be off. At this point, you must charge
myPower ALL Plus.
1. With the output cable disconnected from myPower ALL Plus and the power switch in either position, press
and hold the voltage selector/capacity button to check the capacity.
or
With the output cable connected to myPower ALL Plus and the power switched to OFF, press and hold the
voltage selector.
or
With the device connected, the power button
switched to ON, and the light under the
voltage selector glowing to indicate the
voltage is locked, press and hold the voltage
selector. (Please note that if the voltage
indicator is unlocked, indicated by the
absence of the glowing light under the
voltage indicator, pressing the voltage
selector will change the voltage which
may cause harm to the connected device.)
2. To view the voltage selection, release the
voltage select and the battery capacity
indicators will turn off. One indicator will
remain on to indicate the voltage selection.
1st Blue Indicator 1-5% (Recharge before using)
2nd Blue Indicator 5-15%
3rd Blue Indicator 15-25%
4th Blue Indicator 25-40%
5th Blue Indicator 40-55%
6th Blue Indicator 55-70%
7th Blue Indicator 70-85%
8th Blue Indicator 85-100%
CAPACITY INDICATOR