Toshiba SR-C8002 - Manual (Page 23)

18/24 SR-C8002 Rev.1.0
ATA Command for ATAPI
N o . OP Code Command Description
- 00h Nop
1 08h ATAPI Soft Reset
2 20/21h Read Sector (s)
3 90h Execute Drive Diagnostics
4 A0h ATAPI Packet Command
5 A1h ATAPI Identify Device
6 E0h Standby Immediate
7 E1h Idle Immediate
8 E2h Standby
9 E3h Idle
10 E5h Check Power Mode
11 E6h Sleep
12 E7h Flush Cache
13 ECh ATA Identify Device
14 EFh Set Feature
7. Power Requirements
7.1. Source Voltage +5 V +/-5 % (Operating)
+5 V +/-8 % (Start up)
7.1.1. Spike 100 mV
(p-p)
Max.
7.1.2. Ripple 100 mV (p-p) Max.
7.2. Current Drain (Typical value) +5 V
7.2.1.Sleep 40 mA
7.2.2.Standby (Laser off, Motor off) 70 mA
7.2.3. Continuous Read (Data/Audio) 620 mA (4-6X)
900 mA (10.3-24X)
7.2.4.Idle (Laser on, Motor on) 600 mA (10.3-24X)
7.2.5. Average (20% Random Access) 900 mA (10.3-24X)
7.2.6. Maximum (100% Random Access) 950 mA (10.3-24X)
7.2.7. Peak in executing Access 1,650 mA
(Exclude Spike Current)
*Spike: Less than 1 ms of duration
7.2.8. Write 760 mA (CD-R/RW)
820 mA (High Speed CD-RW)