Toshiba 27HL95 - Manual (Page 26)

Chapter 3: Using the remote control
26 Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
(E) 27HL95 *Web 213 : 276
SKIP
Skips back to beginning of current DVD
chapter or locates previous chapters.
SKIP
Skips forward to locate later DVD
chapters.
STOP
Stops the tape or DVD.
PLAY
Begins playback of a tape or DVD.
PAUSE
Press during play or record mode to
pause the picture; press again to restart.
CH y z
y selects the next higher channel;
z selects the next lower channel.
(for channels programmed into
memory only)
CLEAR
Press to reset the title and chapter
number.
y z x •
Press to navigate DVD menus (may not
work on some DVD players).
TV GUIDE
Opens the TV Guide On Screen ® .
Channel Numbers (0-9)
Press to directly access channels (as
opposed to CH
y z ).
POWER
Turns the selected device on and off.
Using the remote control to operate a cable
converter box, satellite receiver, VCR, DVD player,
or HTIB (home theater in a box)
If you have a non-Toshiba device or a Toshiba device that the remote control is not
preprogrammed to operate, you must first program the remote control to recognize the
device (if you have not already done so). See pages 24 and 25.
To use your TV remote control to operate a:
• Cable converter box or satellite receiver, set the Device Switch to CBL/SAT.
• VCR, set the Device Switch to VCR.
• DVD player or HTIB, set the Device Switch to DVD.
Note:
Even after the TV remote control is
programmed, it may not operate certain features
on your other device. If this happens and you
wish to use those features, you will need to use
the device’s original remote control.
FF
Fast-forwards the tape or DVD.
(Press during play mode to view the
picture moving rapidly forward.)
Point the remote control
directly at the device.
+10
Press to directly access
DVD chapters higher than 10.
TOP MENU
Accesses a DVD’s top menu.
ENTER
Required by some VCRs and cable
converter boxes to change the channel.
Device Switch
Set to “TV” to control the TV; “CBL/SAT” to
control a cable converter box or satellite
receiver; “VCR” to control a VCR; “DVD”
to control a DVD player or HTIB.
TV/VCR
To view one program while recording
another, press to select TV mode.
REW
Rewinds the tape or DVD. (Press during play mode
to view the picture moving rapidly backward.)
REC
Starts tape recording.
DVD MENU
Accesses DVD menus.
#01E_023-028_27HL95 05.9.12, 15:34 26
Black