Thermador 9000189697 - Manual (Page 27)

27
q Mark a vertical line under the outermost fixing holes
in the adjusting rail.
q Using a square, extend the drill hole marks which
you have just made to the vertical marks.
q Mark and drill the holes.
q Screw on the fixing plates (4x).
22. Attaching the furniture door
(freezer compartment)
i Now fit the furniture handles which are screwed
from behind!
q Hang the furniture door with adjusting rail over the
double threaded bolts.
q Screw the nuts a little onto the double threaded
bolts. Do not tighten!
q Precisely adjust the furniture door.
Align the furniture door with the double threaded
bolts (Torx screwdriver).
q Attach the bracket:
- Lift the furniture door slightly away from the
appliance door.
- Push the side bracket on the left and right over
the screws 1.
- Insert the side bracket on the left and right into
the fixing plate and slide over the screw 2.
Slowly lower the door.
Continue the process until the last side brackets
(3.) have been inserted into the fixing plates and
are positioned on the screws.
i The two upper brackets (1. ć on the left and right)
have no side piece for insertion into the fixing plate.
q Close the door and check that the depth of the
furniture front is aligned with the adjacent fronts.
If required, correct.
q Tighten the bracket screws to fix the depth
alignment.
q Close the door and check the side alignment.
Correct by gently tapping the edge of the open
furniture door with your hand.