Tivoli Audio Model Three - Manual (Page 6)

english
11. MONO/sTeReO: This switch should remain in the Mono position unless the right Stereo or
Dual Alarm Speaker (sold separately) is connected, in which case the Stereo position should be
selected. If you are using the companion speaker and have the switch set to Stereo, you may wish
to experiment with this switch during radio listening, as the Mono position may help to clean up FM
static noise. The Headphone and Record outputs are Stereo and are not affected by this switch,
unless the Source knob is set to AM (which is always Mono) or FM and this switch is set to Mono.
12. TIMe seT: Briefly press and release this button to advance the hands in small increments. Press
and hold this button to continuously advance the clock’s hands. Release the button when the clock
is set properly. Be sure the alarm button is in the Off position when setting the time.
13. AlARM GRIlle: The alarm beep emits from this grille. Do not block this grille
14. bATTeRy bAcK uP: Remove the battery cover and install a fresh major brand 1.5V “AA” al-
kaline battery, observing correct +/ – polarity. The clock operates off of the battery continuously and
the battery also acts as a back up. In the event of a power failure, the battery back up will maintain
the clock’s operation and sound the wake-up tone if the alarm button is in the On position, provided
a fresh battery is correctly installed. The clock face will not illuminate and the radio will not operate
during a power failure in order to conserve battery life. Check the battery’s strength annually and
replace only with a major brand, 1.5V “AA” alkaline battery. If the clock stops operating, replace the
battery. Discard spent batteries according to your state/country’s regulations. Remove the battery if
the Model Three is to be stored or unused for a long period of time.