Troy-Bilt TBTB - Manual (Page 8)

Indexing Button
on inside of
nozzle
Flare Nozzle
Indexing Button
on inside of
nozzle
Concentrator Nozzle
Indexing Button
Detent
Indexing Button
OPERATING INSTRUCTIONS
Fig. 4
Fig. 5
Fig. 6
Fig. 7
8
INTERCHANGING NOZZLES
Use the following instructions to attach or interchange
the two nozzles (Figs. 4 and 5).
INSTALLING FLARE OR CONCENTRATOR
NOZZLE ONTO BLOWER HOUSING
1. Align the indexing button on the inside of the nozzle
with the detent on the housing (Fig. 6).
2. Push the nozzle onto the housing and turn the nozzle
clockwise until it locks (Fig. 7).
NOTE: Make sure the nozzles are installed properly, with
indexing button facing up, before operating the unit.
WARNING: To avoid serious personal injury,
do not insert hands into nozzles when
removing or installing them. WARNING: To reduce the risk of injury,
disconnect power source before removing
nozzles.
WARNING: The nozzles may become worn
and get sharp edges due to rubbing on the
ground. It is suggested to use gloves when
changing nozzles.