Tandy 23-401 - Manual (Page 11)

11
REPLACING THE DC
POWER CORD’S FUSE
If the battery conditioner/charger does
not work using vehicle battery power,
check the fuse in the DC power cord. If
the fuse is blown, replace it with a 3
Amp, 250V fast blow fuse (such as Ra-
dio Shack Cat. No. 270-1009).
Caution: Do not use a fuse with a
higher rating.
Follow these steps to check a fuse and
replace it, if necessary.
1. Disconnect the DC power cord
from the cigarette-lighter socket.
2. Grasp the two ends of the fuse
holder, twist them counterclock-
wise, then pull the ends apart.
3. If the fuse is blown, remove it and
replace the fuse with a new one of
the same size and rating.
4. Grasp the two ends of the fuse
holder, align the cigarette-lighter
plug’s tab with the slot, then push
them together and twist them
clockwise until they lock in place.
Cigarette-lighter plug’s
tab aligned with the slot
23-401.fm Page 11 Friday, August 6, 1999 2:35 PM