Telenetics OMEGA CDMA - Manual (Page 19)

Appendix A
AT Commands
T
o configure the OMEGA CDMA Modem, you issue AT commands from a Data Terminal
Equipment (DTE) connected to the OMEGA CDMA Modem’s serial port. Commands are
sent using a terminal-emulation software program such as HyperTerminal. The terminal-
emulation program must be configured to use the following settings:
™ Baud rate: use the baud rate selected by Switches 1 and 2 on the OMEGA CDMA Modem
(see Table 2-3 on page 14)
™ Data bits: 8
™ Parity bit: none
™ Hardware flow control: enabled
AT commands are organized into the following groups:
™ Basic AT parameters  see page 20.
™ S-registers  see page 21.
™ Basic action commands  see page 21.
™ Cellular CDMA commands  see page 22.
™ QUALCOMM-proprietary commands  see page 19
™ Telenetics-proprietary commands  see page 24.
The following tables summarize the AT commands that the OMEGA CDMA Modem supports.
Page 19