Telex C-2002 - Manual (Page 37)

Remote Control Console
31
Section Parameter Default Programmed
7.4.4.1 PIN Number
4.2.4 Line 1 2 or 4 Wire mode 4 wire
4.2.5 Line 1 RX Impedance 600 ohms
4.2.6 Line 1 TX Impedance 600 ohms
4.3.3 Line 1 RX Input Level 0dbm
7.3.1.2.1 Line 1 LAM-S Release 7 seconds
7.3.1.2.2 Line 1 LAM-S Trigger Level -10dbm
7.3.1.2.1 Line 1 LAM-U Release 7 seconds
7.3.1.2.2 Line 1 LAM-U Trigger Level -10dbm
7.6.1 Line 1 Enable/Disable Enable
7.6.2 Line 1 Tone/Local Tone
7.6.3 Line 1 Crossmute ON
7.6.4 Line 1 Squelch OFF
7.6.5 Line 1 TX Monitor OFF
7.6.6 Line 1 RX AGC ON
7.6.7 Line 1 TX Enable Enabled
7.6.8 Line 1 Unselect Lock Unlocked
4.2.4 Line 2 2 or 4 Wire mode 4 wire
4.2.5 Line 2 RX Impedance 600 ohms
4.2.6 Line 2 TX Impedance 600 ohms
4.3.3 Line 2 RX Input Level 0dbm
7.3.1.2.1 Line 2 LAM-S Release 7 seconds
7.3.1.2.2 Line 2 LAM-S Trigger Level -10dbm
7.3.1.2.1 Line 2 LAM-U Release 7 seconds
7.3.1.2.2 Line 2 LAM-U Trigger Level -10dbm
7.6.1 Line 2 Enable/Disable Enable
7.6.2 Line 2 Tone/Local Tone
7.6.3 Line 2 Crossmute ON
7.6.4 Line 2 Squelch OFF
7.6.5 Line 2 TX Monitor OFF
7.6.6 Line 2 RX AGC ON
7.6.7 Line 2 TX Enable Enabled
7.6.8 Line 2 Unselect Lock Unlocked
7.3.2.1.1 Desk Mic Gain 0dbm
7.3.2.1.2 Handset Mic Gain 0dbm
7.3.2.1.3 AUX input Gain 0dbm
7.3.2.2.1 Min. SPKR level 0dbm
7.3.2.3.1 TX Audio output level 0dbm
7.4.3.1.1.1 DTMF output Level 0dbm
7.4.3.1.1.2 DTMF Hold timer 500 msec
7.4.3.1.1.3 DTMF Keypad Enable Enabled
7.4.3.1.1.4 DTMF Generates PTT Enabled
Section Parameter Default Programmed
7.4.3.1.1.5 DTMF Select Call Timer 7 sec
7.4.3.1.2.1 Guard/Func/Hold Levels 10/0/-20
7.4.3.1.2.2 Guard/Hold Frequency 2175HZ