TC electronic SDN BHD Digital Vintage Reverb DVR2 - Manual (Page 6)

EE
NN
GG
LL
II
SS
HH
6 / DVR2
GLOBAL PLUG-IN CONTROLS
KEYBOARD COMMANDS
In most host applications, the DVR2 Reverb supports keyboard commands for certain
functions. The following key commands are available for all plug-in parameters:
Key Commands in Mac OS X:
Fine Adjust = Apple key + mouse movement
Reset To Default = Alt key + mouse click
Key Commands in Windows:
Fine Adjust = Alt + mouse movement
Reset To Default = Shift + Control + mouse click
User Assignable Key Commands:
Depending on your host application, you have the ability to add your own keyboard
shortcuts to certain buttons. The supported buttons in DVR2 are: Mem., A/B, the pre-
vious/next preset buttons and the “Vintage Reset” button.
A right mouse click on the button will open a pop-up menu. Here you can select to
assign a new keyboard shortcut or to remove a previously assigned shortcut.
Note: The ability to use the assignable key commands highly depends on the host
application. Some applications do not pass key commands on to the plug-in.
SCROLL WHEEL SUPPORT
If you are using a host application that supports this feature, all of the DVR2 knobs
and faders support scrolling on both Windows XP and Mac OS X. Simply roll your
mouse over a knob or slider and use the Scroll Wheel to increment / decrement the
associated parameter.
USER INTERFACE DISABLED
Should your PowerCore be fully loaded and there is not enough free processing on
your DSPs, the plug-in will come up in a “disabled” state. Should this occur, it is
advised to remove the plug-in from the mix.
Note: In case any PowerCore plug-in gets disabled either while loading a session or
during your work (e.g. you forgot to switch on PowerCore prior to loading a session),