TC electronic SDN BHD Digital Vintage Reverb DVR2 - Manual (Page 7)

DVR2 / 7
EE
NN
GG
LL
II
SS
HH
you can always save your session without losing any of the plug-in settings. The last
setting of the plug-in will always be saved, even when it is in “disabled” state! This
also applies to saving presets.
FOCUS FIELDS
You can place your own set of parameters in the 6 focus fields at the bottom of the
plug-in. Making use of the focus fields can give you a better workflow, since you will
not have to switch pages all the time to find the parameters that you work with. You
can assign any parameter to the focus fields, and the focus fields are stored with the
session as well as when you save your presets.
To change the assignment:
• Press the Assign button. The Assign button as well as one of the Focus Fields
will be highlighted.
• Select the Focus Field you wish to link a parameter to, by clicking on that field.
• Click on the parameter you wish to link to the selected Focus Field.
• To get an unassigned (empty) Focus Field, click again on the selected parameter.
• Once you have finished the assignments, click again on the Assign button
to leave the assign mode.
OVERLOAD INDICATION (O/L)
The O/L-LED in the metering section, on the left side of the input meters, will light up
in case internal DSP overloads are detected. You should lower the input level to avoid
these overloads. To reset the indication, click on the O/L LED.