Tascam GA-30CD - Manual (Page 14)

1
TASCAM GA-30CD
Use.the.effect.selection.( § ,. ¶ ).keys.to.the.left.of.the.
effect.parameter.table.to.choose.an.effect.–.delay,.
panning.delay,.flanger,.phaser,.chorus,.tremolo,.
auto-wah,.pitch.shifter.–.or.turn.the.effects.OFF..
The.effect.indicators.to.the.left.of.the.effect.names.
show.the.active.effect..No.indicators.light.when.the.
effects.are.OFF..Use.the.three.
EFFECTS .knobs.( 1 ,. 2 .
and. LEVEL ).above.the.effect.parameter.table.to.adjust.
the.parameter.amounts..Refer.to.the.chart.below.for.
details..
Effect controls
Effect 1 2 LEVEL
FLANGER SPEED
Set.modulation.frequency.
(0.1.–10.Hz)..
DEPTH
Set.modulation.depth. FEEDBACK LEVEL
Set.feedback.level.
PHASER SPEED
Set.modulation.frequency.
(0.2.–.20.Hz).
RESONANCE
Set.resonance.amount. LEVEL
Set.effect.amount.
CHORUS SPEED
Set.modulation.frequency.
(0.1.–.10.Hz).
DEPTH
Set.modulation.depth. LEVEL
Set.effect.amount.
TREMOLO SPEED
Set.modulation.frequency.
(0.2.–.20.Hz).
WAVE TYPE
Set.modulation.wave.shape..0.is.
triangle,.center.is.sin,.and.10.is.
sawtooth.
DEPTH
Set.effect.amount..Set.higher.to.
increase.modulation.amplitude.
AUTO.WAH SENSITIVITY
Set.Auto.Wah.sensitivity. Q
Set filter characteristic. Set higher to
increase.the.effect.
Not.used..(Automatically.set.to.
maximum.)
PITCH.
SHIFTER
PITCH
Set.pitch.shift.amount.up.to.±1.
octave..The.center.position.is.0.
FINE
Set.pitch.shift.amount.up.to.±50.
cents..The.center.position.is.0.
LEVEL
Set.effect.amount.
DELAY DELAY TIME
Set.delay.time.(10.ms.–.1.1.sec). FEEDBACK LEVEL
Set.feedback.level. LEVEL
Set.effect.amount.
PANNING.
DELAY
DELAY TIME
Set.delay.time.(10.ms.–.1.1.sec)..Sent.
to.L.and.R.side.speakers.alternately.
FEEDBACK LEVEL
Set.feedback.level. LEVEL
Set.effect.amount.
Effects
The.GA-30CD.has.built-in.effects.(top.panel).and.
reverb.(front.panel)..The.guitar.signal.passes.through.
the.preamp,.including.
GAIN ,. BASS ,. MIDDLE .and.
TREBLE .tone.adjustments,.before.being.processed.by.
the.effects..
Selecting effects and setting parameters
To.restore.the.effects.to.their.factory.settings,.use.the.
FXRS .item.in.the.Setup.menu..(See.“Initializing.effect.
banks”.on.page.19.for.details.)
Restoring the factory effect presets
5 – Using effects