Tricity Bendix TB 090 FF - Manual (Page 18)

18
Door Reversal
The diagram shows the model TB 116 FF.
1. Disconnect the appliance from the electricity
supply.
2. Gently lay the fridge/freezer on its back with the
top held away from the floor by 5-8 cm (2-3
inches) of packaging.
3. Prize out the two white screw covers from the
ventilation grille at the bottom of the appliance.
4. Remove the two securing screws and remove the
grille.
5. Unscrew the bottom hinge.
6. Remove the door by releasing it from the middle
hinge.
7. Unscrew the middle hinge.
8. Slide out the fridge door from the pin, unscrew the
pin and then screw it into the hinge blade provided
on the opposite side.
9. Refit the fridge door on the opposite side and
replace the middle hinge to the left hand side.
10. Replace the door and bottom hinge on the
opposite side.
11. Remove the plug from the ventilation grille in the
direction of the arrow (1) and insert it on the
opposite side (2).
12. Refit the ventilation grille. Secure with the two
screws and push in the screw covers.
13. Return the appliance to its upright position.
Important
After completion of the door reversing operation,
check that the door gasket adheres to the cabinet. If
the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that case,
wait for the natural fitting of the gasket or accelerate
this process by heating the part involved with a normal
hairdryer on a low setting.