Activate channel 1, Activate talk and listen, Activate channel 2 – Telex SS-1002 User Manual
Page 18: Channel select (ss-2002 & ss-2002rm only), Headset/headphone/speaker/microphone selection, Receiving calls
16
To adjust sidetone on SS-2002 and SS-2002RM headphones, do the following:
1.
Activate channel 1.
2.
Activate talk and listen.
3.
Set the volume control to the normal listening level for intercom audio.
4.
While talking into the microphone, use a small, flat-head screwdriver to adjust the channel 1 sidetone trimmer so
you can hear your own voice in the headphones at an acceptable level.
5.
Activate channel 2.
6.
Repeat the steps 1 - 5 to adjust the channel 2 sidetone.
Channel Select (SS-2002 & SS-2002RM Only)
To select a channel on the SS-2002 and SS2002RM, do the following:
>
Tap the Ch Select key to select channel 1 or 2.
The key is green when channel 1 is selected and red when channel 2 is selected.
Headset/Headphone/Speaker/Microphone Selection
•
To use a headset or telephone style handset:
set the Speaker and Panel Mic keys to off.
•
To use headphones with the built-in panel microphone:
set the speaker key to off.
set the panel mic key to on.
make sure a gooseneck microphone is not inserted in the panel microphone connector.
•
To use headphones with a gooseneck microphone,
set the speaker key to off.
set the panel mic key to on.
make sure a gooseneck microphone is inserted in the panel microphone connector.
•
To use the speaker with a handheld dynamic microphone:
set the speaker key to on.
set he panel mic key to off.
•
To use the speaker with the built-in panel microphone:
set the speaker and panel mic keys to on.
make sure a gooseneck microphone is not inserted in the panel microphone connector.
•
To use the speaker with a gooseneck microphone:
set the speaker and panel mic keys to on.
make sure a gooseneck microphone is inserted in the panel microphone connector.
Receiving Calls
When there is an incoming call signal, the call key flashes red. There is a beep tone in the headphones or speaker if the beep
feature is activated.
NOTE:
The incoming call indication is provided only for the currently selected intercom channel in the case of SS-2002
& SS-2002RM models.
To receive calls, do the following: