Toshiba XM-6802B - Manual (Page 7)

5
Power Cable - Connect an internal computer power
supply cable to the power socket at the back of the CD-
ROM drive. One side of the plug has chamfered edges,
so the power connector fits only one way. Push plug
completely into the socket making sure the plug fits
correctly.
Figure 4.Installing Power Cable
Audio Cable (optional) - If you have a sound card and
speakers, and would like to play audio CDs on your
computer, you will need to install a CD audio cable.
Toshiba's CD-ROM drives use a standard 4-pin audio
cable that can be purchased from most local computer
suppliers. The sound cable connects to your sound card
at one end and the other end connects to the digital
audio connector at the left rear of the CD-ROM drive
(see CD-ROM drive Back Panel
photo for location).
Refer to the instructions that came with your sound card
for details on any sound-driver software required
.
Figure 5.Installing Audio Cable
Completing Installation
After you have connected all the necessary cables,
push the CD-ROM drive completely into the
computers drive slot. Mount drive per your computers
instructions. The screw length should not exceed
30.5mm (measured from outside surface of side or
bottom of drive to tip of screw). Replace computer
cover and all outer screws.
Figure 6.Mounting Illustration
Software Driver - Toshiba's optical drives do not require any unique device drivers for Windows
'95/'98/2000/Me/XP/NT. After installing your drive and re-booting, your system should recognize your
drive. Windows '95/'98/2000/Me/XP/NT Operating Systems support all Toshiba optical drives natively If
you prefer using DOS, download the DOS ATAPI driver from our web site.