Appendix b: glossary – TP-Link TL-WN321G User Manual

Page 21

Advertising
background image

TL-WN321G

54M Wireless USB Adapter User Guide

Appendix B: Glossary

¾

802.11b - The 802.11b standard specifies a wireless networking at 11 Mbps using

direct-sequence spread-spectrum (DSSS) technology and operating in the

unlicensed radio spectrum at 2.4GHz, and WEP encryption for security. 802.11b

networks are also referred to as Wi-Fi networks.

¾

802.11g - specification for wireless networking at 54 Mbps using direct-sequence

spread-spectrum (DSSS) technology, using OFDM modulation and operating in the

unlicensed radio spectrum at 2.4GHz, and backward compatibility with IEEE 802.11b

devices, and WEP encryption for security.

¾

Ad-hoc Network - An ad-hoc network is a group of computers, each with a wireless

adapter, connected as an independent 802.11 wireless LAN. Ad-hoc wireless

computers operate on a peer-to-peer basis, communicating directly with each other

without the use of an access point. Ad-hoc mode is also referred to as an

Independent Basic Service Set (IBSS) or as peer-to-peer mode, and is useful at a

departmental scale or SOHO operation.

¾

DSSS (Direct-Sequence Spread Spectrum) - DSSS generates a redundant bit pattern

for all data transmitted. This bit pattern is called a chip (or chipping code). Even if one

or more bits in the chip are damaged during transmission, statistical techniques

embedded in the receiver can recover the original data without the need for

retransmission. To an unintended receiver, DSSS appears as low power wideband

noise and is rejected (ignored) by most narrowband receivers. However, to an

intended receiver (i.e. another wireless LAN endpoint), the DSSS signal is recognized

as the only valid signal, and interference is inherently rejected (ignored).

¾

FHSS (Frequency Hopping Spread Spectrum) - FHSS continuously changes (hops)

the carrier frequency of a conventional carrier several times per second according to

a pseudo-random set of channels. Because a fixed frequency is not used, and only

the transmitter and receiver know the hop patterns, interception of FHSS is extremely

difficult.

¾

Infrastructure Network - An infrastructure network is a group of computers or other

devices, each with a wireless adapter, connected as an 802.11 wireless LAN. In

infrastructure mode, the wireless devices communicate with each other and to a

wired network by first going through an access point. An infrastructure wireless

network connected to a wired network is referred to as a Basic Service Set (BSS). A

set of two or more BSS in a single network is referred to as an Extended Service Set

(ESS). Infrastructure mode is useful at a corporation scale, or when it is necessary to

connect the wired and wireless networks.

¾

Spread Spectrum - Spread Spectrum technology is a wideband radio frequency

technique developed by the military for use in reliable, secure, mission-critical

communications systems. It is designed to trade off bandwidth efficiency for reliability,

- 16 -

Advertising