Tascam D00935220B - Manual (Page 17)

IMPORTANT SAFETY INSTRUCTIONS
TASCAM 202 MK IV
1
TASCAM 202 MK IV
1
Recording (either TAPE 1 or TAPE 2)
1. Turn on the power.
2. Load a tape for recording.
Side “A” facing you
Press the EJECT key ( ø ) to open the cassette
compartment. Insert the cassette tape with its
open edge facing down, side “A” facing you.
Then close the cassette compartment by push-
ing in the cassette door until it clicks shut.
NOTE
If the erasure prevention tabs of the loaded cas-
sette tape have been broken off, stick a piece of
adhesive tape over the hole(s).
With this cassette deck you can use Normal (Type
I) and Chrome (Type II) tapes for recording.
3. Set the REV MODE switch.
Ä : Set to this position to record on one side
only.
Ê or ä : Set to either of these positions to
record on both sides.
•
•
4. Set the DOLBY NR switch.
Set the switch to ON to record with Dolby Noise
Reduction.
Set to OFF to record without Dolby Noise Reduc-
tion.
5. Press the RECORD key.
The deck enters the record-pause mode. π and
will light on the display.
6. Adjust the recording level.
Start playback of your recording source and set
the
REC LEVEL control knob so that the level
meter indicates “0 dB” at peaks.
7. Set the recording direction.
Recording is made in the direction indicated by
the play/record direction indicator (
˙ / ¥ ). To
change this direction, press the opposite direction
play key (
˙ or ¥ ).
NOTE
Be careful not to press play key whose arrow
points in the same direction as the indicator.
Doing so will start recording.
4 − Recording