Tascam D00935220B - Manual (Page 25)

IMPORTANT SAFETY INSTRUCTIONS
TASCAM 202 MK IV

4 − Recording
TASCAM 202 MK IV

Connecting a commercially available timer to your
audio setup lets you wake up to your favorite cassette
tape, or start recording at specified times.
Refer to the illustration below, and connect your audio
components.
4. Set the REV MODE switch to the required posi-
tion.
To let both decks play continuously, set the REV
MODE switch to the ä (CONT PLAY) position.
5. Set the DOLBY NR switch.
6. Set the TIMER switch to the PLAY position.
7. Set the audio timer to the required start (power
on) and stop (power off) times. When this set-
ting is completed, the power to all components
will be switched off.
When a preset start time is reached, power will be
supplied and playback will start automatically.
Playback automatically starts also by simply
pressing on the
POWER switch of this deck.
When you don’t use the timer, set the TIMER
switch to the OFF position.
Playback always starts from side “A”.
AC concent
Audio source
( To make a timer-
controlled recording
of a radio program,
s e t yo ur tu n e r a s
required.)
Amplifier
(Set the input /output
selectors and others to
the proper positions.)
Timer
Signal flow
At
recording
time At
playback
time
Timer-controlled recording
(Example: Recording a broadcast program)
1. Connect this unit and stereo system to a com-
mercially available audio timer.
2. Set the POWER switch of all components to
ON.
3. Load a recordable cassette tape(s) in TAPE 1
or ll (or both decks for continuous recording).
4. Set the REV MODE switch to the required posi-
tion.
For continuous recording on both decks, set the
REV MODE switch to the
ä (CONT PLAY)
position.
5. Set the DOLBY NR switch as required.
6. Tune in a broadcasting station to be recorded.
7. Press the RECORD key of the deck to be re-
corded to set the deck to the record-pause
mode.
8. Adjust the recording level.
9. Set the TIMER switch to the REC position.
10. Set the audio timer to the required start (power
on) and stop (power off) times. When this set-
ting is completed, the power to all components
will be switched off.
When the preset start time is reached, power will
be supplied and recording will start automatically.
Recording automatically starts also by simply
pressing on the
POWER switch of this deck.
When you don’t use the timer for a while, be sure
to set the
TIMER switch back to the OFF position
to prevent accidental erasure of your important
tape.
Recording always starts from side “A”.
Connections with a timer