Tyler Refrigeration Lift Front Straight Glass Meat/Seafood/Deli Merchandiser TLF - Manual (Page 29)

Installation & Service Manual TLM, TLF, TLD
Page 29
Lift-Glass Replacement
WARNING
Wear safety glasses and gloves and use
at least two people when replacing glass.
Glass is heavy and weight distribution is
uneven. Mishandling of glass could cause
breakage and/or personal injury.
If replacing glass:
1. Raise the old glass to the full UP position.
NOTE
Glass is heavy and requires assistance
for properly support.
2. With assistants firmly holding both ends
of the glass, loosen the set screws on
the bottom of each hinge with an allen
wrench. After set screws are loosened,
slide old glass assembly to right or left
to remove from hinges.
6. Note position of old heater wire and foil
tape. Unpug heater wire from harness
connector and remove foil tape and
heater wire. Install new heater wire and
foil tape in same position as removed.
7. Plug-in the new heater wire at the
harness connector.
8. Reinstall front cladding, bumper
components and color band in
reverse order.
Front Glass Anti-Fog Fan Replacement
1. Lift and tlit out the lower front cladding
to remove from front of case.
NOTE
The bottom of the front upper cladding
may have to be pulled out slightly to
access the top fan mounting screws.
2. Disconnect defogger fan power cord.
3. Remove four screws and defective fan
from fan brackets.
4. Install new defogger fan on fan brackets
and secure with four screws. Reconnect
the defogger fan power cord.
5. Reinstall the lower front cladding.
September, 2004