Trango Broadband PTZ-900 - Manual (Page 2)

rev E Trango Systems, Inc. 3
Quick-Start Guide
1 Prior to installing the wireless link, verify proper operation of PTZ
controller (keyboard) and hard-wired receiver/driver or dome.
2 Determine the bit rate and interface (RS232 or RS485/422) of the
hard-wired system. If it is not 9600 bps and RS485/422, you will need
either to change the setting of the PTZ controller and receiver/driver
or to change the settings of the PTZ-900 equipment. See the end of
this manual for information on changing PTZ-900 internal settings
using TrangoLink software.
3 Wire the terminal block with shielded twisted-pair cable as shown
on pages 8 and 9.
4 After making the necessary adjustments to the internal settings and
cables, connect the system as shown on page 4 and test the wireless
link at short range to verify operation before installing permanently.
5 Install PTZ-900 transmitter and receiver units in desired locations
to 2 3 /
8
″ diameter steel pole and oriented as shown on page 3. The pole
must be securely mounted so that it does not move.
6 Install antennas above the enclosures and position as shown on page 3.
Important! The PTZ-900 TX (transmitter) uses a special antenna con-
nector. Use only the AD900-9-P or the AO900-3-P antenna, otherwise
damage to the unit may occur.
Use extreme care when installing antennas near power lines. You
can be killed if the antenna comes in contact with the power line.
7 Fasten the antenna cables to receiver and transmitter only finger-
tight (no more than 8 lb/in. of torque). Tighten flange around cables.
Apply a small amount of silicone to the flange openings to make a
leakproof connection.
8 Connect shielded twisted-pair interface cables to units through
flanges. Tighten flanges. Important! Power adapter must be kept dry.
9 Verify that LED is illuminated, then tighten down the enclosure’s lid
M-PTZ_E.p65
All rights reserved.
© 2002 Trango Systems, Inc.
15070 Avenue of Science, Suite 200
San Diego, California 92128
+1 858-653-3900
[email protected]
www.trangosys.com
PTZ-900 Installation and Operating Instructions
.
Do not apply power to the transmitter unless the antenna is con-
nected. Permanent damage to the unit may result.
The PTZ-900 TX transmitter’s effective radiated output varies
between 0.5 and 4 watts, depending on the transmit antenna
used. Although transmissions are of a short duration, it is rec-
ommended that the transmit antenna be kept at least three feet
away from nearby people. Important note to installer: This warn-
ing is for FCC exposure requirements.