Team Products CM9130 - Manual (Page 6)

Models/Modelos
CM9130
Owner’s Manual
Manuel de Usuario
to reverse setting, move the Forward/Lock/Reverse switch until it is flat against
the opposite side of the drill. Keeping the Forward/Lock/Reverse switch in the
center position locks the drill and prevents unintentional use. It is recommended
that the Drill is in the locked position when it is not in use or is being stored.
CAUTION: Always check the direction of the rotation before using the drill.
The speed of the drill is increased by the amount of pressure you place on the
ON/OFF trigger switch. The less pressure you put on the trigger switch, the
slower the drill will go.
Your drill comes with an automatic braking function that quickly stops the chuck
from turning when the trigger switch is released.
Screwdriver Operation
Place the point of the screwdriver bit into the head of
the screw and apply slight pressure to the tool. Press
the trigger switch slightly and then gradually increase
the drill speed. Release the trigger switch as soon as
the clutch engages.
Note: Starting the drill at too high of a speed can
damage the drill bit or reduce the life of the bit.
Make sure that the driver bit is inserted straight in the
screw head or the screw may become damaged or will
not be inserted properly. When driving wood screws,
pre-drill pilot holes into the surface to make driving
easier. This will also prevent the wood from splitting.
Note: When drilling, the drill bit can become stuck.
If this happens, a very high torque will be produced. Always take care to hold
the drill firmly to prevent possible damage or injury.
TROUBLESHOOTING TIPS:
DRILL DOES NOT WORK?
• Recharge the battery
CHARGING INDICATOR LED NOT ILLUMINATED DURING RECHARGING?
• Check that battery pack is properly connected to the charger
• Check that the Charger is properly connected at both ends
Maintenance
Clean the Drill regularly. Before cleaning, remove the battery pack and any
accessories (bits etc.). To clean, use ONLY a mild soap and damp cloth on the
housing. Never immerse drill in any kind of fluid. Do not use any solvents or
harsh abrasives on the drill housing as this may cause damage to the unit.
Always keep the ventilation openings clear.
NOTE: All bearings in these tools are lubricated with a sufficient amount of
high-grade lubricant for the life of the unit under normal operating conditions.
No further lubrications required.
CAUTION: DO NOT keep the trigger switch pressed in with tape or any other
permanent means or the circuit will not function properly. A malfunction may
result, possibly causing overheating or damage to the unit.
Do not open the drill, battery or battery charger. There are no user serviceable
parts. Opening the unit will void the warranty.
ACCESSORIES
Please refer to section “Accessories”
9 10